![]() This in turn is scratched and then a thin ‘setting’ or ‘skimming coat’ is used to create a smooth surface. Often referred to as a ‘scratch’ coat, the first plaster coat creates a reasonably flat surface and is ‘scratched’ in a diamond pattern to provide a key for the next coat.įor good-quality work, a ‘floating coat’ or a ‘straightening coat’ is applied next and is worked until perfectly level. If staining continues to persist, consider ‘dry lining’ by fixing battens to the wall and applying laths and lime plaster.If you decide to replaster stained areas, when the problem is not severe it is sometimes suggested to use a slurry of cow dung painted on to the masonry before applying new lime plaster.Where staining appears through a chimney breast it may be necessary to replaster.Ensure the wall has been allowed to dry out fully before applying plaster.Always treat the cause of any damp problems, not the symptoms.Soot staining from flues can often be seen on the surface above a fireplace. If these continue to come to the surface, plaster may have to be stripped. Where damp is present, salts may pose a problem. Unlike modern plasters, lime plasters that have become wet generally dry out with their integrity intact so need not be removed. Use a steam stripper to remove stubborn coatings, being careful not to allow steam to penetrate the plaster.Apply warm water or proprietary wallpaper stripper with a sponge or brush.Gently use a scraper but avoid scoring through the surface into the plaster.Always undertake a test first on a small unobtrusive area.When removing, proceed with care and be aware that wallpaper may be acting as a support to defective plaster underneath. Wallpapers, paints and other finishes can spoil the appearance of plaster surfaces and may trap moisture. Where the bond with laths has failed, reinforce by pouring fresh plaster from above and strengthening with a jute scrim set into this and secured to the joists.Always use screws for any fixings to avoid vibrations to fragile ceilings.Investigate from above if access is available from a loft or by carefully lifting floorboards.Problems with ceilings frequently result from the plaster bond having failed, structural movement, failure of joists, damp problems and rotten or beetle-infested laths. ![]() Removing a loose section of old lime plaster Mending sagging or cracked ceilings Alternatively, gypsum may sometimes be added to a lime plaster mix for the same purpose.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |